HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07-0 | Mail: [email protected]
Safety instructions
Risk of falling! When installing the beamer on the lift it might fall down. To attach the beamer to
the lift, you may need a platform or a ladder for each person. A platform is preferable to a ladder.
Make sure that the platform and / or the ladder is secure.
Danger of falling of the beamer on bystanders during operation. Fix the beamer.
Make sure that the beamer including the plugged-in cable does not protrude beyond the permit-
ted installation space in order to avoid collisions between the projector and the lift or surroun-
ding components during operation.
Risk of shear due to surprising start of the lift while installing the beamer. If the ceiling mount
starts up unexpectedly during the installation process, fingers could be sheared off. Before
installing the beamer, disconnect the ceiling mount from the power supply and put the plug in
sight so that you can supervise it immediately to prevent unauthorized insertion. Move the lift to
the lower position before separating the energy connection.
Risk of electric shock! If the beamers power cable gets into the mechanics of the lift, this can
damage the cable insulation and make parts of the lift conductive. It is therefore essential to
route the cables in the energy supply chain.
Installation of the beamer within the lift (standing)
•
Move the lift to the lowest position.
•
Disconnect the power supply to the lift by pulling the power plug. Place the power
plug in sight to prevent accidental insertion by an uninvolved person.
•
Fix the beamer using the included mounting materials.
•
Attach one end of the cable guide to the platform and the other end to the
ceiling. When installing, make sure that the cable guide does not protrude beyond
the installation surface of the projector when it is retracted.
•
Lay all the required cables in the cable guide, making sure that they are the
correct length. The cables must not be pulled too tight or get caught. Note: The lift
is provided with a cable duct that is suitable for a limited number of cables. We do
not recommend cables with large diameters as these cannot be suitable for mobile
installation due to their large bending radius.
•
Now restore the power supply to the lift. Test the proper installation of the
beamer by means of a test run before you release the ceiling bracket for use.
•
Make sure that the trial run runs smoothly and that there is enough space for the
beamer, substructure and lift.