123
VII.
SERVICE AND MAINTENANCE
D. LUBRICATION
NOTE:
Failure to properly lube pivot points may
result in unnecessary wear and damage.
QUAD PULLERS-
Each quad puller head has four bearings
equipped with grease zerks (fig. 123-2). To ensure the longest life
and best performance, grease each bearing twice a day: suggested
times are morning and noon.
FIG 123-2
FIG 123-1
OUTRIGGER FOLD-
The left and
right outriggers have a grease zerk in the
folding joint between the center tool bar and
the either outrigger (fig. 123-3).
When the combo is being used, this
zerk should be greased a minimum of every
50 hours.
LIFT ARM ASSEMBLIES-
Each lift arm assem-
bly has four grease zerks. The is one zerk at each end
of the upper and lower lift arms (fig. 123-4).
When the combo is being used, these pivot points
need to be checked daily and greased a minimum of
every 50 hours.
FIG 123-3
FIG 123-4
SERVICE AND MAINTENANCE