background image

www.hager.com

Safety instructions

Electrical equipment must only be installed and assembled by a qualified electrician in 
accordance with the relevant installation standards, regulations, directives and safety 
and accident prevention directives of the country.

Failure to comply with these installation instructions may result in damage to the  
device, fire or other hazards.

Function

The device combines a BS socket outlet with a single/twin USB port charging unit.

ON/OFF 
switch

2 USB 
ports

ON/OFF 
switch

USB 
port

Switched socket with 1 USB

Switched socket with 2 USB

Socket features:

The BS socket outlet is compatible with BS 1363-1 plugs. It can be switched ON/OFF using 
the integrated single pole switch.

USB features:

 

-

The USB port charging unit is suitable for charging most portable electronic devices con-
nected via a USB type A plug.

 

-

It is supplied independently of the ON/OFF switch position.

 

-

With dynamic load recognition

 

-

Short-circuit proof and overload proof

Correct use

 

-

For the flush-mounted installation in standard wall boxes  

(recommended wall box depth ≥ 35 mm).

 

-

Only suitable for use in indoor areas with no drip and no spray water.

13A single switched USB
Hager Muse

Installation manual

Summary of Contents for Muse WGMS113SUSBKB

Page 1: ...tch USB port Switched socket with 1 USB Switched socket with 2 USB Socket features The BS socket outlet is compatible with BS 1363 1 plugs It can be switched ON OFF using the integrated single pole switch USB features The USB port charging unit is suitable for charging most portable electronic devices con nected via a USB type A plug It is supplied independently of the ON OFF switch position With ...

Page 2: ...ge 220 240 V Frequency 50 60 Hz Socket rated current 13 A Switch type single pole Conductor cross section of screw terminals min 1 x 1 5 mm max 2 x 4 mm Distance of fixing holes 60 3 mm Socket compliance BS 1363 2 and SS 145 2 USB output 5 V d c USB output current max 2 4 A Standby power consumption of USB unit 150 mW USB compliance IEC 62368 1 Operating temperature 5 45 C Relative humidity no con...

Page 3: ...on Frame 1 Notch Carefully loosen the frame on the notch with a flat blade screwdriver or similar tool Lift up and remove the frame 1 Connecting the device E N L 2 Strip connection cables approx 10 12 mm Wire the device according to the connection diagram 2 Installing the device into the wall box example 2 USB version 3 After wiring fix the device with the two screws attached into the wall box 3 ...

Page 4: ... charging unit before carrying out insulation resistance testing see figure below ç Before insulation resistance testing Remove the frame Insert a flat blade screwdriver into the small hole next to the tool symbol and open the lid The USB charging unit is disconnected After insulation resistance testing Click After insulation resistance testing close the lid until it clicks into place The USB char...

Reviews: