Brown/White
On
Blue/White
Off
Brown
0V (Common)
Supply input connection
x4 Max
x4 Max
KLCM-OS
1 Head Sensor (inc 10m RJ11)
KLCM-3OS
3 Head Sensor (corridor sensor, inc 10m RJ11)
KLCM-5OS
5 Head Sensor (wide area sensor, inc 10m RJ11)
KLO*RJ45G
RJ45 Switch Drop (plug-to-plug), Grey
KLO*RJ45R
RJ45 Link lead (plug-to-plug), Red
KLORJ45CON
RJ45 Splitter
*5, 10, 15, 20, 30, 40, 50
Hager strongly recommends the use of Hager
supplied RJ54 cables for all installations. All
Hager leads are tested prior to shipment. If
other manufacturers RJ45 cables are used
we recommend that each lead is tested with
a dedicated RJ45 tester prior to installation.
Should Hager be called to site to support the
installation and a fault is found with the RJ45 cables, then a
charge for site support will be incurred.
Partition switching
For partition switching please use switch input 1 only.
Sollysta Wiring Accessories for use with Klik
Klik LCM Control Connection
WMGS13R
2 way & centre off retractive switch module, on/off, dim up/down
WMGS12
20A, 2 way, single pole switch
WMGKS
20A, double pole keyswitch for emergency override
WMGP*(1, 2, 3, 4, 6, 8)
White moulded, grid switch cover plates
WMGP*(1, 2, 3, 4, 6, 8)G
Grey moulded (Part M), grid switch cover plates
WMGF*(1, 2 & 34)
Grid frames, 1, 2 and 3/4 gang
Decorative finishes also available for grid products, see Hager catalogue.
Scene control plates, brushed steel, are available on request, 4 scenes, on/dim up, off/dim down.
Standard Switch Drop
Default operation on power up (pre-commissioning)
Switch inputs - 1 to 4 on KLCM
Emergency test, override, corridor hold, in & out.
(
KLCM413WIET
, emergency test not applicable)
COM
LOOP
N
L1
L2
Orange/White
Orange
Green/White
Blue
Blue/White
Green
Brown
Brown/White
Override - All Outputs On
Override - All Outputs Off
Corridor Hold Line
Emergency Test (Timer 1)
Emergency Test (Timer 2)
Emergency Test (Timer 3)
Common
Not Used.
WMGS13R
- 20A, 2 way, centre off retractive grid switch - white
For the latest range information or assistance call our sales service centre on 01952 675 675 or technical service centre on 01952 675 689 or hager.co.uk
The default settings on power up of the LCM is Presence with a 20 minute time out. Therefore any lights connected will not come on (to prevent a building being
lit 24/7).
To enable any light plugged in to the LCM to come on prior to final commissioning (i.e. during other building works) we recommend temporarily connecting a
KLCM-OS
. This will enable all lights to come on for 20 minutes unless the sensor is triggered, this also reduces the requirement to power off LCM at night and
could also aid building security during construction or renovation works.
RJ45 Link Lead
RJ45 Link Lead
RJ45 Link Lead
Klik LCM
Installation Instructions
2
ZD0782 - Issue 3 10-17
ZD0782
ZD0782