8300 Low Energy Auto-Operator
Quick Start Guide
I-EA00259
Rev 1, Rev Date: 1/16/2019
Always visit www.hagerco.com for the latest Installation Instructions
HAGER COMPANIES 139 Victor Street, St. Louis, MO 63104 • (800) 325-9995
This guide is intended to aide in the quick set-up of the operator assembly by experienced and qualified individuals.
This guide is not intended to eliminate the need of the Installation and Service Manual nor is it meant to eliminate the
need to reference any ANSI performance standards to help ensure safe operation. Hager recommends that all
installations and service of this equipment be performed by qualified individuals who are certified inspectors by the
American Association of Automatic Door Manufacturers.
8300 Quick Start Guide
2-1/16"
4.5"
4.75"
4.5"
4.75"
Push Arm
Hollow Metal
Pull Arm
Hollow Metal
2-3/8"
1.5"
Bottom of operator 1/8"
below bottom of frame
STEP 1:
HEADER / OPERATOR / ARM INSTALLATION
Install the header back-plate as shown.
Install drive module and door arm
according to the application.
OPERATOR VIEW AS INSTALLED ABOVE DOOR
Inside face of hinge jamb to C/L of Arm
Mount Bracket
(X)
Inside face of pivot jamb to Spindle
Inside face of pivot jamb to C/L of
Arm Mount Bracket
13.5"
10.5"
16"
Inside face of hinge jamb to Back Edge of
Slide Track
(Y)
Inside face of pivot jamb to Spindle
Inside face of pivot jamb to Back
Edge of Slide Track
7.5"
10.5"
8"
HINGE HUNG DOORS
CENTER PIVOTED DOORS
PUSH
APPLICATION
PULL
APPLICATION
PUSH
APPLICATION
I/O BOARD IS TOWARDS HINGE JAMB
LHR
RHR
PULL
APPLICATION
MOTOR IS TOWARDS HINGE JAMB
LH
RH
X
Push Arm
Y
Pull Arm
Page 1 of 2
