FRAME
WHEN ASSEMBLING TO SPINDLE
PINION FLAT
L
H
R
POSITION OF MAIN ARM
RIGHT HAND DOOR
90 RIGHT ANGLE
1-3/8"
(35mm)
1-3/4"
(44mm)
1"
(25mm)
12"
(305mm)
5-1/2"
(140mm)
3/4"
(19mm)
A
1. PARTS
3. INSTALL CLOSER
2. MARK AND DRILL HOLES (
Right Hand Shown)
4. INSTALL MAIN ARM
5. INSTALL MAIN ARM AND
CONNECTING ROD
7. ADJUSTMENTS
8. INSTALL COVER
COVER
Select hand of door and degree
of door opening. Fold template
on the corresponding line for
desired degree of door opening
and hand. Match this line with
the hinge edge of door and
attach template to door. Be sure
frame line on template lines up
with the bottom edge of frame
face. Mark, prep and drill/tap
1/4"-20 holes for closer body
and jamb shoe mounting screws.
Remove template and use mounting screws
to install the closer body to the door and the
jamb shoe to the frame. Closer body should
be oriented so that the speed regulating valves
are toward the hinge stile of door.
Slide cover over closer body and secure
by tightening screws.
Orient main arm so that the “H”, located on
the main arm, lines up with the flat on the
spindle. Press arm down on spindle and
secure with spindle bolt.
Slide connecting rod into forearm of main arm.
Rot n down forearm screw.
Door Opening
Dimension “A”
To 100
7-1/2"
(191mm)
6"
(152mm)
4-1/2"
(114mm)
101 to 130
131 to *180
*Door/Wall/Hardware/Jamb
conditions permitting
Speed regulating valves toward hinge edge.
5200 Series Door Closer - Regular Arm
Installation Instructions
Meets ANSI A156.4
2
HAGER COMPANIES
139 Victor Street, St. Louis, MO 63104 • (800) 325-9995 • Fax (800) 782-0149
See Adjustments on Page
6 for setting Spring
Power, Sweep Speed,
Latch Speed, and
Backcheck.
NOTE:
Do not fully unscrew valves or
hydraulic fluid will leak and closer will
no longer be functional.
Identify direction of hold-open nut according to hand of
door and mount arm.
Adjust by loosening hold-open nut, then open door to
desired position and tighten hold-open nut securely.
6. OPTIONAL HOLD-OPEN ARM
RH
LH
RH
LH
