ENGLISH
FRANÇAIS
ESP
AÑOL
6.
Close the remaining inlets by sliding the slider against the tubing
or wires to prevent escape from feeding insects and
smaller animals
7.
Place the
Exo Terra
®
Thermostat
on a solid, level surface.
8.
Connect your heating device (Heat Mat, Heat Cable, Ceramic
Heater, Heat Bulbs, etc.) to the receptacle of the thermostat.
Controls heating devices up to 600W.
INSTALLATION in other Terrarium Models
1.
Refer to your terrarium’s instruction manual for instructions on
how to install equipment, wiring and sensor cables inside the
terrarium.
2.
Position the sensor inside your terrarium, in the location where
you want to reach the temperature set on the Blue LCD Screen.
This can be on top of the substrate if you are using a Heat Mat
or Heat Cable, but this can also be on a branch, cave or pile of
stones if you are using a Ceramic Heater or Heat Bulb to heat up
a certain basking area.
3.
Place the
Exo Terra
®
Thermostat
on a solid, level surface.
4.
Connect your heating device (Heat Mat, Heat Cable, Ceramic
Heater, Heat Bulbs, etc.) to the receptacle of the thermostat.
Controls heating devices up to 600W.
WARNING: Do not overload the Exo Terra
®
Thermostat by
connecting heat devices with outputs greater than 600W.
Damage from overloading is considered misuse and is exempt
from the guarantee.
OPERATING INSTRUCTIONS
The Exo Terra
®
Thermostat should be set according to the needs
of the animals. Thoroughly research the preferred optimum
temperature range (POTR) for your specific reptile, so you can
create the correct temperature gradients inside the terrarium to
allow your reptiles to thermoregulate.
Always use a thermometer to monitor the inside temperatures
of your terrarium. Adjust the Exo Terra
®
thermostat according to
the required temperature range for your pet’s environment.
Choose between DIMMING or PULSE PROPORTIONAL mode
The Exo Terra
®
600W Thermostat with Day/Night function can be
switched from Dimming function to Pulse Proportional function
if desired. The Dimming or Pulse Proportional mode will provide
the most accurate temperature control and virtually eliminates
temperature swings.
•
The standard setting of the Exo Terra
®
600W Thermostat with
Day/Night function is the Dimming mode, but in case you prefer
to use the Pulse Proportional mode, press and hold the pinhole
(C/F) on the back of the thermostat with a pen or similar tool
for 3 seconds and the mode will change from Dimming to Pulse
Proportional. In Dimming mode, the “°C” or “°F” symbol on the
Blue LCD screen will show constantly, when in Pulse Proportional
mode the “°C” or “°F” symbol on the Blue LCD screen will flash
every 2 seconds. To switch back to Dimming mode press and
hold the pinhole (C/F) on the back of the thermostat with a pen
or similar tool for 3 seconds once again and the setting will
reverse to Dimming mode.
