Hafele Classic 80-B eDrive, Instruction Manual, Page: 19 / 26

Slido Classic 80-B eDrive Version 1.0
Instruction Manual 19/26
6
Initial operation
6.2 Steps during initial operation
W A R N I N G
Moving door leaf
Danger of injury by squashing, shearing or collision, caused
by moving door leaf.

Keep area clear during initial operation.
Prepare control device

Carry out electrical connections.

Refer to chapter 5.2

Set configuration.

Refer to chapter 6
Perform reset

Switch power supply on.

Control device in delivery status or after power cut:
Red LED blinks continuously twice with a short break of 1.5 sec.

Press RESET for about 2 seconds.

Red LED blinks continuosly.

Check driving direction of motor with control keys:
When pressing OPEN, door has to open and when pressing CLOSE, door has to close.

When driving direction is wrong:
Swap motor cables (terminals MA and MB), check driving direction again.

Move door in a middle position by pressing and holding the control keys.

Press RESET for about 2 seconds.

Red LED lights up permanently,
green LED lights up during motor activity.

Door moves in the open position,
door moves in the closed position,
door moves in the open position.

LEDs go out.
Check functionality

Test, if door shows desired behavior.

In case of malfunction check electrical connections and configuration.

For electrical connection refer to chapter 5.2

For configuration refer to chapter 6.1

Repeat initial operation, if necessary.

Initial operation is completed, when function is correct.
…
…
…