Häfele IN FK339.6GBF, Instruction Manual

Page: 19 / 24

19
WARRANTY AND AFTER-SALE SERVICES
Warranty
Warranty service as stated on the warranty card
The manufacturer shall not be held liable for any damage caused by improper use of the product.
CHANGING THE DIRECTION OF THE DOOR OPENING
1. Unplug the appliance.
2. Remove the bottom rail, gently pulling it towards you (item 1).
3. Remove the caps C using a flat screwdriver
4. Holding the refrigerator door, remove the hinge assembly (item 6), remove the door by lifting them
up parallel to the appliance body. Remove the pin from the upper hinge and screw it on the other
side of the hinge (item 6).
5. Remove the pin pads located in the refrigerator door lower strip (item 5). Remove the cap from the
middle hinge pin hole it the upper strip of the freezer door (item 9).
6. Remove the caps from the mounting holes for the middle hinge (item 8).
7. Holding the freezer door (item 3), remove the middle hinge (item 4), remove the door by lifting it up
parallel to the appliance body.
8. Unscrew the bottom hinge (item 7), remove the pin and insert it into the opposite hole (item 2).
Remove the bottom rail handle located on the other side of the refrigerator body.
9. Attach the lower hinge on the other side of the appliance body. Position the freezer door in such a
way so that the lower hinge pin is aligned with the appropriate hole in the door.
10. The remaining door installation steps should be performed analogically to the above.
12. Check the door position towards the body of the appliance. If the door is in the correct position, use
the caps to cover the holes in the body and doors and install the lower cover.
13. Remove the door handles and attach them on the other side of the refrigerator and freezer door. To
remove the handle, remove the screw caps (item A) and remove the screws. Move the handle to
the side (in the direction of the previous handle position) and gently pull it forward. Install the handle
analogically to its removal.
Remember about the pads located on the hinge pins. Reuse them when changing the direction of
opening the door.
The installation kit does not include a screwdriver or wrench.
Changing the direction of the door opening should by carried out by two persons.
EN