Häfele HDW-T5531B, User Manual

Page: 29 / 84

29
Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1 ) German degree of measurement for the water hardness
2 ) millimol, internationel unit for water hardness
* factory setting
3 ) Every cycle with a regeneration operation consumes additional 3.0 litres of water,
the energy consumption increases by 0.02 kWh and the program extents by
4 minutes.
0 - 5
6 - 11
12 - 17
18 - 22
23 - 34
35 - 45
dH
0 - 0.9
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.1
6.2 - 8.0
Mmol/l
Digital display stalls
WATER HARDNESS
H1
H2
H3
H4
H5
H6
Setting on the
water softener
1
2
3
4
5
6
1) 2)
*
Regeneration occurs
every X program
sequence 3)
No regeneration
10
5
3
2
1
1.
, switch on the appliance;
2.
, press the
button for more than 5 seconds to start the water softener ;
3. Press the Program button to select the proper according to your local
environment, the will change in the following sequence:
H4->H5->H6->H1->H2->H3->H4;
4.
Without any operation in five seconds or press the Power button to end the
, the setting is memorized by the .
Close the door
Within 60 seconds after the appliance was switched on
Programme
setting mode
again setting
setting
setting
mode programme