732.28.424
HDE 26.07.21
6/12
en
3. Standalone Mode
3.1. Standalone Mode with 4-Channel Interface as Provisioner
To conigure a network without the App, you can use the 4-Channel Interface as the provisioner (controller). By this
you can provision mesh boxes with monochrome, multi-white lights or RGB lights.
Attention: Only one wall switch can be used to control the network. In case more 4-channel interfaces are required,
please use the Remote Control Standalone Mode or use the Connect Mesh App.
3.1.1. 4-Channel Interface Standalone Mode with Monochrome Lights
To start, the 4-Channel Interface needs to contain a irmware version of at least 4.4.6
(otherwise please update) and needs to be reset (status led blinks).
1. Start the search for mesh boxes by pressing the two upper buttons for 4 seconds. The led will start
blinking (slowly).
2.
Find and conigure Mesh Box: When the led starts to blink fast, a mesh device is found and will get
conigured.
3. To stop searching for other mesh boxes, press any button of the switch. To start searching again, continue
with step 1.
The buttons of the switch will control the mesh box in the following way:
•
First button: Controls port 1 and 4 (on/of, dimming)
•
Second button: Controls port 2 and 5 (on/of, dimming)
•
Third: Controls port 3 and 6 (on/of, dimming)
•
Forth button: Controls all ports (on/of, dimming)
Group 3
• ON/OFF:
Single Click
• Dim Up/Down:
Longpress
[Image 3]
Coniguration same like Connect Mesh Wall Switch
Group 1
• ON/OFF:
Single Click
• Dim Up/Down:
Longpress
Group 2
• ON/OFF:
Single Click
• Dim Up/Down:
Longpress
Group ALL
• ON/OFF:
Single Click
• Dim Up/Down:
Longpress
Constant Power
Group 3
Group 1
Group 2
Group 3
Group 1
Group 2
