Hafco DS-12H, Instruction Manual

Page: 11 / 15

Canister Filter
1. Remove the inlet port that came with the
sander.
2. Mount the plastic elbow (A, Fig. 9) to the
sander using the same hardware (B, Fig. 9)
from the inlet port.
3. Connect the filter (C, Fig. 9) to the elbow and
turn counter-clockwise so that it locks in
place.
Lt.
WARNING
Static eiectricity will · build up in the filter
during operation. The filter ground must be
<!ttached to the machine ground, and to the
filter. Failure to comply may result in fire/loss
of property, or personal injury!
4. Remove the screw (D, Fig. 9) from the
sander base. Attach the end of the
grounding wire to the screw and thread back
in to the base.
5. Attach the grounding clip (E, Fig. 9) to the
metal part of the filter. This will prevent
static electricity from building up in the filter.
Cleaning the Filter
Lt.
CAUTION
Wearing a particle mask/respirator for
protection against fine dust particles during
cleaning Is highly recommended.
Clean the canister filter frequently to keep the
sander's performance at its optimum. To clean:
1. Disconnect the machine from the power
source.
2. Take off the grounding clip and remove the
filter (C, Fig. 9) by turning clockwise.
3. Empty the contents into an appropriate
container.
4. The filter can be cleaned with a low pressure
air hose. Blow from the outside of the filter
to clean the dust particles. For best results
check and empty the filter frequently.
5. Install the filter and reattach the grounding
clip.
E
Fig. 9
l 0
Page 11 Instructions Manual for DS-12H (L134) 07/08/2017