Hafco Metalmaster HM-53GV, Operation Manual

Page: 4 / 54

3
12. Never attempt any operation or adjustment if the procedure is not understood.
13. Keep fingers away from revolving parts and cutting tools while operating.
14. Do not attempt to adjust or remove tools during operation.
15. Always keep cutters sharp.
16. Keep away from the turning handwheel, especially high speed.
17. Must pour the machine oil into the gear box and the power feed (optional) rightly.
18. Failure to comply with all of these warnings may cause serious injury.
1. Attention
1.1 inspection and acceptance
Please check carefully when open the package and make sure no parts are missing.
1.2 safety
Please read the operation manual carefully before the installation and adjustment of
the machine. When finish the installation, check all the details and trial run the
machine idlly before put it into operation.
1.3 caution
Keep in mind the safety measures for electrical and operating protection.
2. Work environment
2.1 the elevation of workshop has to be 2000rpm or less.
2.2 no conductive dust allowed.
2.3 no explosive factor allowed.
2.4 no corrosive gas or steam which may corrode metal or damage the insulation.
2.5 keep away from the source of impact or vibration.
3. Operation instruction