1. These are the components used in the assembly of the Stand.
2. Using these screws, washers and
nuts, fit the Shelf to the Legs.
3. Lay a Leg on the floor and fix one end of the Shelf as shown. (Note: The
Shelf will fit only one way—”tray” facing up). Do not fully tighten these
screws yet.
4. Fix the other Leg to the Shelf,
again do not fully tighten these
screws.
5. Fit the Corner Brackets inside a leg as shown. This is the end the Handle
will be fixed to. Finger tighten these 2 bolts first, then fully tighten.
6. Fit the Corner Brackets and
Wheel Bracket to the other Leg.
Finger tighten these 4 bolts first,
then fully tighten.
7. Turn the Saw Stand up the right way, preferably on a non slip surface.
Lift the Saw on top of the Stand with 2 people ensuring the top of the
Stand fits inside the Saw Base. Make sure the motor is at the end with
the Wheel Bracket. Have the other person steady the Saw until all bolts
are tightened as it is unstable until completed.
BS4A (B002) Bandsaw Assembly Instructions
4/2/2014
Page 1 of 3
Shelf
Wheel Bracket
Screws for Shelf
Wheel Bracket
