English
3
Electrical connection
Check whether the electrical voltage that you intend to use is the same as that of the machine.
Details are to be found on the label on the base.
Connected Wattage
The total power consumption of this device can be up to 2200W. With this connected load a
separate supply line protected by a 16A household circuit breaker is recommended.
CAUTION: OVERLOAD:
-
If you use extension leads, these should have a cable cross-section of at least 1.5 mm2.
-
Do not use any multiple sockets, as this device is too powerful.
Use
1.
Place the machine on a flat surface.
2.
Open the kettle with the button in the lid. Fill it with water. Fill only up to the maximum mark
(MAX). You can read off the water level in the water level indicator.
3.
Close the lid.
4.
Place the kettle flush on the base.
5.
Only connect the machine to a properly installed 230V, 50Hz safety socket.
6.
Switch to position 1 (ON). The LED indicator will light up to indicate that the water is being
boiled.
7.
After boiling the machine switches off automatically. Disconnect the machine from the mains
electricity
Cleaning
WARNING:
-
Always turn the device off before cleaning it and remove the mains plug. Wait until the
device has cooled down.
-
Never immerse the device or the base in water or other liquids.
CAUTION:
-
Do not use any wire brush or other abrasive objects.
-
Do not use any acidic or abrasive detergents.
-
Rinse the water container out with clean water. Then dry it off with a cloth.
-
Clean the housing after use with a slightly damp cloth.
Decalcification
•
The frequency of the decalcifying operation depends on the hardness of the water and on
how often the appliance is used.
•
If the machine switches off before the water boils, it probably needs to be decalcified.
•
Please do not use vinegar but a commercially available decalcification agent on the basis of
citric acid. Only use the quantities stated in the instructions.
Summary of Contents for Tucson EK-22B.003A
Page 2: ...A B C F D E ...
