© Hach Company, 2007, 2014. All rights reserved. Printed in Germany.
Edition 2 March 2014
For technical assistance or ordering information: visit
www.hach.com
, call 800-227-4224 or email [email protected]
Quick Start Guide
For si792 D series 2-wire transmitters
DOC016.53.00797
Additional Configuration
Note:
Additional configuration is for 4-20mA /Hart version only. For Foundation Fieldbus or Profibus PA,
refer to the user manual for configuration instructions.
Refer to
Table 4
for default passcode settings.
1.
To enter the configuration mode, press
CONF
, configuration code:
1200
,
ENTER
. There are 5
configuration menus:
• current output "out.1MNU"
• temperature compensation "tc MNU"
• corrections configuration "Corr MNU"
• Calibration setup "Cal MNU"
• alarm settings "ALrt MNU"
2.
In configuration mode, press the
RIGHT ARROW KEY
to navigate to a specific configuration
menu. Press
ENTER
to access the menu options.
3.
Use the
ARROW KEYS
to edit values. Press
ENTER
to save the settings. If a value is outside of
the acceptable range, “Err” will be displayed and the value will not be accepted.
4.
To exit the configuration mode and return to measurement mode, press
CONF
,
ENTER
at
any time.
Refer to user manual for detailed configuration instructions and a complete list of menu options.
Table 4 Default passcode settings
Display
Function
Default setting
Cal INFO
Calibration information
0000
CAL 0-CAL
Calibration zero
1001
CAL CAL
Calibration Saturation/Concentration
1100
CAL PROD
Product calibration
1105
CAL RTD
Temperature sensor adjustment
1015
CFG ERR
Error information
0000
CFG CONF
Configuration
1200
CFG SNSR MO Probe monitor
2222
CFG OUT
Current source
5555
CFG SPCL ST
Administrator passcode. Use
ARROW
keys to
select NO or YES
1989
NO SPCL ST
Do not change
administrator passcode
Press
ENTER
to return to the default
passcode
Press
CONF
to exit the editor
YES SPCL ST
Change administrator
passcode
Press
ENTER
to accept the new
passcode
Press
CONF
to exit the editor