2
sc1000 Panel Mount Bracket
Panel mount bracket installation
1.
Determine the location of the bracket on the panel. Allow enough room for the strain
relief pass-through or optional bulkhead connector pass-through to be located within a
228.6 mm (9 in.) radius of the bottom mounting screw (
Figure 1
).
2.
Install three customer-supplied # 10 pan head or equivalent low profile head screws
into the panel (
Figure 1
, item
1
).
3.
Hang the sc1000 panel mount bracket over the screws.
4.
Hang the sc1000 display module on the panel mount bracket (
Figure 2
, item
8
).
5.
Drill the pass-through hole for the strain relief fitting or the optional bulkhead
connector within a 9-inch radius from the bottom mounting screw location (
Figure 1
).
Figure 1 Panel mount dimensions
1
Bracket mounting holes (3x)
3
Maximum 9-inch radius for pass-through holes
2
Pass-through hole, 26.746 mm (1.053 in.), for strain
relief (supplied)
4
Pass-through hole, 12.319 ± 0.381 mm
(0.485 ± 0.015 in.) for optional bulkhead connector
(Cat. No. 71211-00, not supplied)
