3.
Select
BASIC MODE
.
4.
Push
RETURN
to restart the instrument.
Configure the system
System settings control how data is measured and stored, user permissions and other system-
wide parameters. System settings can be configured as part of instrument commission, or changed
later for different applications.
Set the time and date
Time and date will need to be set at initial commissioning.
1.
On the Counter Navigation screen, push
SYSTEM
.
2.
Select the
Basic
tab.
3.
Select the Time field. Use the numeric keypad to enter the current time in the HH:MM:SS format,
then confirm.
4.
Select the Date field. Use the numeric keypad to enter the current date in the YYYY-MM-DD
format, then confirm.
Set the sleep mode and backlight timeout
Sleep mode and backlight time are active during battery use. When the instrument is connected to
AC power, sleep mode and backlight are not active.
During sleep mode the instrument goes into hibernation after a period of inactivity to conserve power.
All subsystems are shut down. The time value for sleep mode is in minutes.
The backlight setting turns off the LCD backlight after a period of inactivity to conserve power. The
time value for the backlight setting is in seconds.
1.
On the Counter Navigation screen, push
SYSTEM
.
2.
Select the
Basic
tab.
3.
Select the Sleep Time field. Enter the length of idle time before sleep mode begins, then confirm.
The range is 1 to 30 minutes.
Note: Enter 0 to disable sleep mode.
4.
On the
Basic
tab, select the Backlight Timeout field. Enter the length of idle time before the user
interface backlight turns off, then confirm. The range is 5 to 300 seconds.
Note: Enter a value of less than 5 seconds to disable backlight timeout.
To bring the instrument out of backlight timeout, use a finger or a stylus to make the user
interface touchscreen active.
Set the Alarm Reasons option
To capture data about why alarms occur, the Alarm Reason option is set as Required or Optional. In
both Required and Optional mode, the user is prompted to select from preset alarm reasons for the
alarm event. All users can enter alarm reasons. Only administrators, factory-level users or users with
System Settings permissions can disable or change the Alarm Reasons option.
To enable or disable Alarm reasons:
1.
On the Counter Navigation screen, push
SYSTEM
.
2.
On the
Units and Alarms
tab, push
.
3.
On the Alarm Reasons screen, select
REQUIRED
,
OPTIONAL
or
DISABLED
for more information.
Note: The Alarm Reasons option is set to Disabled by default.
20
English
Summary of Contents for MET ONE 3400 Series
