Hach CM130, User Manual

Page: 48 / 112

3. Select Date.
4. Enter the current date.
To erase characters, select
and push ok .
5. Select Continue.
6. Select Time.
7. Select am or pm.
8. Enter the current time.
To erase characters, select
and push ok .
9. Select Continue.
Configure the network settings
Enter the TCP/IP addresses of the analyzer, subnet mask, default gateway and network time
protocol (NTP) server(s). The TCP/IP addresses are supplied by the network administrator.
1. Push menu .
2. Select Settings.
3. Select an option. Refer to Figure 17 .
Option Description
Static IP Sets the TCP/IP address of the analyzer.
Subnet IP Sets the TCP/IP address of the subnet mask for the analyzer.
Gateway IP Sets the TCP/IP address of the default gateway for the analyzer.
Primary NTP IP (Optional) Sets the TCP/IP address of the primary network time protocol (NTP) server
for the analyzer. The NTP server supplies the date and time to the analyzer.
Secondary NTP IP (Optional) Sets the TCP/IP address of the network time protocol (NTP) server for the
analyzer that is used if communication with the primary NTP server is lost.
Note: Make sure to configure the primary NPT IP before the secondary NTP IP is
configured.
4. After the TCP/IP addresses are entered, select Reset.
5. When the reset is complete, push back .
Figure 17 Settings Screen—Static IP
46 English