Hach Ultra MET ONE 227, User Manual

Page: 51 / 59

50
When all the SW-1 settings are complete, the printer prompts the user to select
CONTINUE
by pressing the
ONLINE
button or
WRITE
by pressing the
FEED
button. If SW-2
and SW-3 settings are correct, select
WRITE
to exit the programming routine and save
the settings. If SW-2 settings are correct, but SW-3 settings need to be changed, SW-2
settings must be programmed first in order to access SW-3 settings. If the SW-3 settings
are modified, the printer will automatically exit the DIP-SW programming mode after the
last position is set and print "DIP SW setting complete!!". Make sure that the printer is
online when the programming is complete.
Table 5 DIP switch settings
Dip switch 1
1 (OFF) : Input = Serial
2 (ON) : Printing Speed = High
3 (ON) : Auto Loading = On
4 (ON) : Auto LF = On
5 (ON) : Setting Command = Enable
6 (ON) : Printing
7 (ON) : Density
8 (ON) : = 72 %
Dip switch 2
1 (ON) : Printing Columns = 40
2 (ON) : User Font Back-up = ON
3 (ON) : Character Select = Normal
4 (ON) : Zero = Normal
5 (ON) : International
6 (ON) : Character
7 (ON) : Set
8 (OFF) : = U.S.A
Dip switch 3
1 (ON) : Data Length = 8 bits
2 (ON) : Parity Setting = No
3 (ON) : Parity Condition = Odd
4 (ON) : Busy Control = H/W Busy
5 (OFF) : Baud
6 (ON) : Rate
7 (ON) : Select
8 (ON) : = 9600