EN
The pump
Note:
1. Pump components are fastened by rotating the pump
lid between the upper and lower slits of the cartridge
2.
threads
3.
4. The standing components and the cartridge are con-
nected with bolts.
Caution
1. Do not use the pump when there is no water in the pool
2.
cables and the plug are in perfect condition.
3. Voltage and frequency must comply with those stated.
4. The transformer must be kept at a distance of at least 3,5
meter from the pool.
5. The transformer, cable and plug must be kept dry.
6.
make sure that the transformer has been disconnected
from the electricity supply.
7. If the power cable is damaged, the pump must not be
used.
8. This device is not for intended for use by persons (inclu-
ding children) with limited physical, sensory or mental abi-
lities or those with lack of experience and/or lack of know-
ledge, unless they have been given the task by a person
responsible for their safetyor have received instructions
on how to use the device.
9. Children should be superviced to ensure that they do not
play with the device.
10. If the connecting cable on this deviceis damaged, it must
be replaced by the manufacturer of his After Sales Service
11. Do not lift or move the pump by pulling on the power cable.
Part description
1. Casing
2. Filter Cartridge
3.
4. Floating ring
5. Transformer
6. Bracket
7. Pump unit
The bracket and clamp
drive screw and the
hexagon nut.
1
2
3
5
6
7
4
Never let the pump turn dry;
his leads to damage !
1.
2. In order to avoid the pump sucking air, submerge the
pump at least 15 cm below water level.
3. The water temperature must not be above 35° C
4. During winter avoid the pump becoming frozen
5. The pump switches on immediately after plugging the
transformer into the socket .
Cleaning and servicing
1.
2. Remove the pump by twisting the pump unit
3. Clean the parts
Winter
1. Unplug the pump from the power source.
2.
frost and severely cold temperatures. In a garage or
insulated storage shed is recommended.
fault using the following table, please
♦ switch the device o
ff
♦ unplug it
Problem
Cause
Possible remedy
Motor does not run
No electricity
Check electricity source,
switch and wiring (have
them repaired or replaced by
professionals)
Impeller is blocked
Dismantle pump and clean it
Windings burnt out
Replace pump
Motor runs but little or no
water is drawn in
Pump is not fully submerged
in water
Raise water level or lower
pump
Impeller damaged
Filter insert clogged
Rotor turns in the wrong
direction
Switch transformer off and
then back on again
Motor runs intermittently Impeller is blockedor is
permanently overloaded
Clean cartridge and protect
transformer against over-
heating
Summary of Contents for Clean plus
Page 1: ...Clean plus 1298_89173 ...
Page 3: ......
