Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Hot Press PM-306/160
Author:
A.T. / KM
INSTALLATION
Edition: 09/2005
Page
C-7
Replaces:
C.4
Disassembling of the hot-pressing device
Hot-pressing device dismantling operations must be performed by:
Technicians of HABASIT Assistance Service.
Technicians authorized by HABASIT, with experience of: Machine assembly/disassembly.
Assembly/disassembly of the electrical, pneumatic and hydraulic plant, consulting the corresponding
diagrams.
ATTENTION
BEFORE CARRYING OUT ANY KIND OF WORK ON THE HOT-PRESSING DEVICE IT IS
ESSENTIAL TO ENSURE THAT THE SYSTEMS (ELECTRICAL, PNEUMATIC AND WATER) ARE
DISCONNECTED FROM ENERGY SUPPLIES, THAT PNEUMATIC AND WATER IS PROPERLY
DEPRESSURISED AND THAT THERE IS NO REMAINING POTENTIAL ENERGY IN THE MOVING
PARTS.
ATTENTION
Follow the following disconnection procedure:
Disconnect the electrical circuit.
Disconnect the water circuit.
Disconnect the air circuit.
Carry out mechanical disassembly.
If the hot-pressing device has to be stored for a certain time, prepare it as indicated in the next section,
but if it has to be handled immediately, refer to the appropriate section.
Hot-pressing device PM-306/160
