Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Hot Press PM-1606
Author:
S.D.T. / KM
INSTALLATION
Edition: 02/2005
Page
C-2
Replaces: 01/2002
C.1
Preparation of working area
ATTENTION
The hot-pressing device must be placed on a floor or support of suitable size that is able to take the
weight and bulk of the equipment.
The machinery must be placed in a room with sufficient lighting, avoiding dazzling and stroboscopic
effects. Personnel entrusted to control the hot-pressing device must be able to work under normal light
conditions (usually provided by neon lights fitted on the ceiling). If the lighting level is insufficient, the
Customer must provide an additional lighting system since the machinery is not supplied with its own
lighting system for the operational zone.
The work area must be well ventilated and/or have an air cycling and emission system compliant with the
law of the country of installation, such as to ensure the operator is working under the proper working
conditions.
The free space around the machine must be sufficient for work and maintenance operations and permit
access all workstations taking account of the size of the pieces to be worked on.
The Customer must provide all the sources of energy required for electrical power and compressed air as
indicated in
TECHNICAL CHARACTERISTICS OF THE HOT-PRESSING DEVICE
Ensure there is sufficient operational space around the press.
Make sure that there is a properly stocked first aid box on site nearby.
ATTENTION
The main switch of the electrical panel must be in its «OFF» position when the hot-pressing device is
being connected up.
Hot-pressing device PM-1606
