Habasit Italiana S.p.A.
Vittorio Veneto 31029 (TV)
Tel.: ++39(0)438.9113
Fax. ++39(0)438.200545
Hot Press PM-1606
Author: S.D.T.
/KM
REGULATIONS AND GENERAL WARNING NOTES
Edition: 02/2005
Page
A-5
Replaces: 01/2002
A.4
Guarantee conditions
A.4.1
Guarantee terms and validity
The manufacturer guarantees the product against any faults either in materials or in workmanship, for 1
(one) year from the date of installation of the product at the Buyer’s premises. In this case, the
manufacturer shall limit itself to replacing or repairing any part or parts returned to the manufacturer,
which was/were found to be faulty.
The manufacturer may, at his own discretion, also replace or repair any part or parts of the product being
repaired that is/are felt to be defective.
The manufacturer shall have the sole right to decide if such parts should be repaired or replaced.
The manufacturer shall not be liable in any other case for collateral or incidental damage.
The guarantee does not apply to plant that has been repaired by third parties that have NOT been
authorized by the manufacturer.
Spare parts supplied by the manufacturer must be used. Any deviation from this rule will mean the
guarantee will not apply.
A.4.2
When the guarantee can be voided
The manufacturer's guarantee for the plant and associated equipment may be annulled as a result of
improper intervention or repairs.
The manufacturer's guarantee for the equipment may be annulled as a result of the use of improper
materials or materials not supplied by the manufacturer.
This manual’s instructions must be observed or the guarantee cover will be lost.
IMPORTANT
HABASIT CANNOT BE HELD RESPONSIBLE FOR ANY DAMAGE CAUSED BY IMPROPER,
INCORRECT AND UNREASONABLE USE OF THE HOT-PRESSING DEVICE.
Hot-pressing device PM-1606
