3
Figure2-5 Inner rail
(1) Release tab
(2) Keyhole slot
Attaching inner rails to the device
1.
Unpack the inner rails.
2.
Pressing the release tab on the inner rail, extend each rail to its maximum length.
3.
Attach an inner rail to the device.
IMPORTANT:
For some devices, you must first remove the transport security screw before attaching inner
rails to them. View the labels on the device carefully to identify the location of transport security
screws.
a.
As shown by callout 1 in
, align the four keyhole slots in the inner rail with the pegs
on the chassis side panel and place the inner rail against the side panel.
b.
, slide the rail toward the chassis rear to lock the rail in
place on the pegs.
4.
Repeat the same procedure to attach the other inner rail to the other side panel of the device.
Figure2-6 Attaching an inner rail to the device
NOTE:
You must set the keyhole slots in the rails over all the four pegs on each side panel of the device. In
, a peg is blocked by the release tab and only three pegs are displayed.
