2-5
6.
Align the AP with the wall/ceiling bracket in the direction as shown
, and rotate the
AP clockwise until it clicks into place.
Figure2-10 Attaching the AP to the wall/ceiling bracket
Mounting the AP on a ceiling
WARNING!
The ceiling for installing the AP must be less than 18 mm (0.71 in) in thickness, and can bear a load
of 5 kg (11.02 lb). If the ceiling is not strong enough, use boards to reinforce the ceiling as a best
practice.
To mount the AP on a ceiling:
1.
Align the guide pins on the AP bracket with the guide holes in the AP, and use a M4 × 7 screw
to attach the AP bracket to the AP, as shown in
2.
Remove the ceiling tile and use the ceiling bracket to mark the installation holes on the ceiling
tile. Drill two holes with a diameter of 5 mm (0.20 in) in the marked positions.
Figure2-11 Drilling holes in the ceiling tile
3.
Thread pan-head screws through the installation holes in the wall/ceiling bracket and into the
holes in the ceiling. Fasten washers and nuts at the other side of the ceiling to attach the
mounting bracket to the ceiling.
1
2
3
