3-2
Installing the AP
The following describes how to install the AP on a wall.
z
Installing the Wall-Mounting Bracket on a Wall
z
Installing the AP on the Wall-Mounting Bracket
z
Locking the AP onto the Wall-Mounting Bracket (Optional)
Installing the Wall-Mounting Bracket on a Wall
Follow these steps to install the wall-mounting bracket on a wall:
Step1
Drill holes 6 mm (0.24 in) in diameter on the wall where the AP should be mounted. The drilled holes
should correspond to those in the wall-mounting bracket. There are eight installation holes in total in the
wall-mounting bracket. You should select at least four holes for installation.
Figure 3-2
Screw hole locations and screw hole size (in mm)
49.0
44.6
22.3
49.1
49.1
150.0
75.0
62.9
104.0
Step2
Insert the pointed end of anchors into the drilled holes and tap the flat end of anchors with a rubber
hammer until they are all flush with the wall surface.
Step3
Align the holes in the wall-mounting bracket with the anchors and insert screws through the installation
holes into the anchors, as shown in Figure 3-3.
Step4
Adjust the position of the wall-mounting bracket and tighten the screws.
