5
CAUTION:
For easy installation and removal of the access point from the mounting bracket, ensure that
there is sufficient flexibility with the cable and that the cable is long enough. H3C recommends
using flexible cables. If not enough cable is routed through the back of the mounting bracket,
or the cable is inflexible, it can be difficult to install or remove the access point from the
mounting bracket.
1.
Remove the access point from the mounting bracket.
2.
Route the Ethernet cable and, if you are using a power adapter, the power cable
on the back of the mounting bracket.
3.
Mount the bracket to a wall or ceiling.
4.
Connect the Ethernet cable and the power cable (if using a power adapter) to the
corresponding port(s) on the access point.
CAUTION:
To avoid connection interference caused by dust, clean the pins of the cable connector
before connecting the cable to the access point.
Discharge the cable before connecting it to the access point.
WARNING:
In case of lightning, do not plug/unplug the cable to/from the access point.
When the LEDs of the access point are blinking, do not plug/unplug the cable to/from the
access point or perform any operation that may affect the normal running of the access point.
5.
Align the bottom of the access point with the mounting bracket, and press against
the access point until it is securely mounted in the mounting bracket. To avoid
physical damage to the access point, do not use excessive force when mounting
or unmounting the access point.
6.
To prevent theft of the access point, insert the locking bar into the opening at one
side of the mounting bracket. Push the locking bar through the opening until the
hole on the locking bar is exposed. Insert the shackle of a lock through the hole on
the locking bar to lock the access point to the mounting bracket.
Mounting the access point on a tabletop
To install the access point on a flat surface such as a table or desktop:
