H3C UniServer R4900 G3, User Manual

Page: 75 / 299

66
Figure 80 Installing a SATA M.2 SSD to the M.2 transfer module
5.
Install the transfer module to a riser card and then install the riser card on a PCIe riser
connector. For more information, see "
Installing riser cards and PCIe modules ."
6.
Connect the SATA M.2 SSD cable to the system board. For more information, see " Connecting
the rear SATA M.2 SSD cable ."
7.
Install the access panel. For more information, see " Replacing the access panel ."
8.
Rack-mount the server. For more information, see " Rack-mounting the server ."
9.
Connect the power cord. For more information, see " Connecting the power cord ."
10.
Power on the server. For more information, see " Powering on the server ."
Installing SD cards
Guidelines
The SD cards are hot swappable.
To achieve 1+1 redundancy and avoid storage space waste, install two SD cards with the same
capacity as a best practice.
Procedure
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Replacing the access panel ."
4.
(Optional.) For the ease of installation, remove the riser card installed on PCIe riser connector 3,
if any. For more information, see "
Replacing a riser card and a PCIe module ."
5.
Orient the SD card with its golden plating facing the dual SD card extended module and insert
the SD card into the slot, as shown in
Figure 81 .