H3C UniServer R4900 G3, User Manual

Page: 131 / 299

122
Verifying the replacement
Log in to HDM to verify that the PCIe Ethernet adapter is in a correct state. For more information, see
HDM online help.
Replacing a M.2 transfer module and a SATA M.2
SSD
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
Replacing the front M.2 transfer module and a SATA M.2
SSD
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Replacing the access panel ."
4.
Remove the chassis air baffle. For more information, see " Removing air baffles ."
5.
Remove the fan cage. For more information, see " Replacing the fan cage ."
6.
Remove the security bezel, if any. For more information, see " Replacing the security bezel ."
7.
Remove the SATA M.2 SSD:
a.
Remove the M.2 transfer module. To remove the module, disconnect the cable connected
to the M.2 transfer module. Then remove the M.2 transfer module in the same way as
removing a SATA optical drive. For more information, see "
Replacing the SATA optical
drive ."
b.
Remove the screw that secures the SSD on the transfer module. Tilt the SSD by the
screw-side edges, and then pull the SSD out of the connector, as shown in
Figure 153 .
Figure 153 Removing a SATA M.2 SSD
8.
Install a new SATA M.2 SSD. For more information, see " Installing SATA M.2 SSDs ."