H3C UniServer R2700 G3, User Manual

Page: 50 / 226

6-14
Installing a standard storage controller and a power fail
safeguard module
Procedure
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Install the flash card of the power fail safeguard module to the storage controller:
IMPORTANT:
Skip this step if no power fail safeguard module is required or the storage controller has a
built-in flash card. For information about storage controllers with a built-in flash card, see
"Storage controllers."
a.
Install the two internal threaded studs supplied with the power fail safeguard module on the
storage controller, as shown in
Figure 6-21 .
Figure 6-21 Installing the internal threaded studs
b.
Slowly insert the flash card connector into the socket and use screws to secure the flash
card on the storage controller, as shown in
Figure 6-22 .