6-5
{
Access the CLI or GUI of the server.
•
Observe the drive LEDs to verify that the drive is operating correctly. For more information, see
"Drive LEDs."
Installing power supplies
Guidelines
•
The power supplies are hot swappable.
•
Make sure the installed power supplies are the same model. HDM will perform power supply
consistency check and generate an alarm if the power supply models are different.
•
To avoid hardware damage, do not use third-party power supplies.
Procedure
1.
As shown in
, remove the power supply blank from the target power supply slot.
Figure 6-8 Removing the power supply blank
2.
Align the power supply with the slot, making sure its fan is on the left.
3.
Push the power supply into the slot until it snaps into place.
Figure 6-9 Installing a power supply
4.
Connect the power cord. For more information, see "
Verifying the installation
Use one of the following methods to verify that the power supply is installed correctly:
•
Observe the power supply LED to verify that the power supply is operating correctly. For more
information about the power supply LED, see LEDs in "Rear panel."
