H3C UniServer R2700 G3, User Manual

Page: 112 / 226

7-29
Figure 7-34 Smearing thermal grease onto the processor
3.
Install the retaining bracket onto the heatsink. For more information, see " Installing processors ."
4.
Install the heatsink onto the server. For more information, see " Installing processors ."
5.
Past bar code label supplied with the processor over the original processor label on the
heatsink.
IMPORTANT:
This step is required for you to obtain H3C's processor servicing.
6.
Install the chassis air baffle. For more information, see " Installing air baffles ."
7.
Install the access panel. For more information, see " Installing the access panel ."
8.
Rack-mount the server. For more information, see " Rack-mounting the server ."
9.
Connect the power cord. For more information, see " Connecting the power cord ."
10.
Power on the server. For more information, see " Powering on the server ."
Verifying the replacement
Log in to HDM to verity that the processor is operating correctly. For more information, see HDM
online help.
Replacing a DIMM
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
Procedure
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Remove the chassis air baffle. For more information, see " Removing air baffles ."
5.
Open the DIMM slot latches and pull the DIMM out of the slot, as shown in Figure 7-35 .