138
Table 65 1000BASE-X-SFP port specifications
Item Specification
Connector type
LC
Transceiver module type
SFP
Interface standards
802.3, 802.3u, and 802.3ab
Operating mode
1000 Mbps, full duplex
Table 66 10GBASE-R-SFP+ port specifications
Item Specification
Connector type
LC
Transceiver module type
SFP+
Interface standards
802.3ae
Operating mode
10 Gbps, full duplex
For the copper combo port specifications, see
.
For the fiber combo port specifications, see
Transceiver modules
For more information about transceiver modules supported by the SR6604 and SR6608 switches,
see
H3C SR6600/SR6600-X Routers Interface Module Guide
.
Lightning protector for a port
Port protective unit–single port, maximum discharge current (8/20
μ
s waveform): 5 kA, output voltage
(10/700
μ
s waveform): core-core < 40 V, core-ground < 600 V.
For how to install the port lightning protector, see "
Installing a lightning protector for a network port
If part of the network cable of a copper Ethernet port must be routed outdoors, connect a lightning
protector to the cable before you plug the cable into the port.
•
Lightning protector for 10/100 Mbps copper Ethernet ports
—Single port, residual pulse
energy (8/20
μ
s test pulse) 2.5 KA, output voltage (8/20
μ
s waveform): core-core
≤
15 V,
core-ground
≤
300 V.
•
Lightning protector for 1000 Mbps copper Ethernet ports
—Single port, residual pulse
energy (8/20
μ
s test pulse) 3 KA, output voltage (8/20
μ
s waveform): core-core
≤
15 V,
core-ground
≤
300 V.
Power strip with lightning protection
If part of the AC power line is routed outdoors, use a power strip with lightning protection to connect
the AC power cord of the router to the AC power line to protect the router from being damaged by
lightning strikes.
You can attach the power strip to the rack, workbench, or wall of equipment room.
The specifications for the power strip with lightning protection that can be installed on the router are
as follows:
