23
MIC-X adapter module components
Figure 20 Screw
Figure 21 Carrier
Figure 22 Front panel
Assembling a MIC-X adapter module and MIC interface module into a MIC-X interface module
1.
Use a screwdriver to remove the four screws from the MIC interface module circuit board so
that the front panel and the gasket are disengaged from the circuit board.
2.
Align the MIC interface module circuit board with the guide rails on the MIC-X adapter module
carrier. Gently push the circuit board into the carrier along the guide rails until the circuit board
makes close contact with the connectors on the MIC-X adapter module carrier.
3.
Install M3 screws provided with the MIC-X adapter module carrier into the two screw holes at
the center of MIC interface module circuit board and fasten the screws.
4.
Select the front panel matching the MIC interface module, align the front panel with the ports on
the circuit board, and use M3 screws to attach the front panel to the circuit board.
The MIC-CLP2L, MIC-CLP4L, MIC-SP4L, MIC-SP8L, MIC-ET16L interface modules can be
assembled into corresponding MIC-X modules by using MIC-X adapter modules.
