H3C SOHO IE4300, Command Reference Manual

Page: 977 / 3296

4
•
reset ipv6 dhcp server ip-in-use
•
reset ipv6 dhcp server pd-in-use
Do not configure the DHCPv6 client on the interface that has been configured as the DHCPv6 relay
agent or DHCPv6 server.
Examples
# Enable the DHCPv6 server on VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ipv6 dhcp select server
# Enable the DHCPv6 relay agent on VLAN-interface 20.
<Sysname> system-view
[Sysname] interface vlan-interface 20
[Sysname-Vlan-interface20] ipv6 dhcp select relay
Related commands
display ipv6 dhcp relay server-address
display ipv6 dhcp server
DHCPv6 server commands
address range
Use
address range
to specify a non-temporary IPv6 address range in a DHCPv6 address pool for
dynamic allocation.
Use
undo address range
to restore the default.
Syntax
address range start-ipv6-address end-ipv6-address [ preferred-lifetime
preferred-lifetime valid-lifetime valid-lifetime ]
undo address range
Default
No non-temporary IPv6 address range exists.
Views
DHCPv6 address pool view
Predefined user roles
network-admin
Parameters
start-ipv6-address
: Specifies the start IPv6 address.
end-ipv6-address
: Specifies the end IPv6 address.
preferred-lifetime preferred-lifetime
: Specifies the preferred lifetime for the
non-temporary IPv6 addresses. The value range is 60 to 4294967295 seconds, and the default is
604800 seconds (7 days).