H3C SOHO IE4300, Command Reference Manual

Page: 2873 / 3296

62
Examples
# Create reaction entry 1 for monitoring the average round-trip time of UDP jitter probe packets, and
set the upper limit to 50 milliseconds and lower limit to 5 milliseconds. Before the NQA operation
starts, the initial state of the reaction entry is invalid. After the operation, the average packet
round-trip time is checked. If it exceeds the upper limit, the state is set to over-threshold. If it is below
the lower limit, the state is set to below-threshold. Once the reaction entry state changes, a trap
message is generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 1 checked-element rtt threshold-type
average threshold-value 50 5 action-type trap-only
# Create reaction entry 2 for monitoring the round-trip time of UDP jitter probe packets, and set the
upper limit to 50 milliseconds and lower limit to 5 milliseconds. Before the NQA operation starts, the
initial state of the reaction entry is invalid. After the operation, the packet round-trip time is checked.
If the total number of threshold violations reaches or exceeds 100, the state of the entry is set to
over-threshold. Otherwise, the state of the entry is set to below-threshold. Once the state of the
reaction entry changes, a trap message is generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 1 checked-element rtt threshold-type
accumulate 100 threshold-value 50 5 action-type trap-only
reaction trap
Use
reaction trap
to configure the sending of traps to the NMS under specific conditions.
Use undo reaction trap to restore the default.
Syntax
reaction trap { path-change | probe-failure consecutive-probe-failures |
test-complete | test-failure [ accumulate-probe-failures ] }
undo reaction trap { path-change | probe-failure | test-complete |
test-failure }
Default
No traps are sent to the NMS.
Views
ICMP echo/TCP/UDP echo operation view
DHCP/DLSw/DNS/FTP/HTTP/SNMP operation view
UDP tracert operation view
ICMP jitter/UDP jitter/voice operation view
Predefined user roles
network-admin
Parameters
path-change
: Sends a trap when the UDP tracert operation detects a different path to the
destination.