H3C SOHO IE4300, Command Reference Manual

Page: 2640 / 3296

7
Predefined user roles
network-admin
Parameters
initial-unidirectional-delay time
: Specifies the delay time for DLDP to block a port
upon an Initial-to-Unidirectional state transition. The value range for the
time
argument is 60 to 300
seconds. If you do not specify this option, DLDP blocks the port immediately upon an
Initial-to-Unidirectional state transition.
Usage guidelines
DLDP can take effect only after you enable it globally and on a port.
When enabling DLDP on a port, you can set the delay time for DLDP to block the port upon an
Initial-to-Unidirectional state transition. If the port does not enter Bidirectional state when the delay
time expires, DLDP blocks the port.
Examples
# Enable DLDP globally, and enable DLDP on GigabitEthernet 1/0/1 and set a delay time of 100
seconds for DLDP to block the port upon an Initial-to-Unidirectional state transition.
<Sysname> system-view
[Sysname] dldp global enable
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dldp enable initial-unidirectional-delay 100
Related commands
display dldp
dldp global enable
dldp global enable
Use
dldp global enable
to enable DLDP globally.
Use
undo dldp global enable
to disable DLDP globally.
Syntax
dldp global enable
undo dldp global enable
Default
DLDP is disabled globally.
Views
System view
Predefined user roles
network-admin
Usage guidelines
DLDP can take effect only after you enable it globally and on a port.
Examples
# Enable DLDP globally.
<Sysname> system-view
[Sysname] dldp global enable