6
Installing and removing the power
module
CAUTION:
Do not install the NSQM2AC1400 power module and other types
of power modules on the same device.
To avoid bodily injury and device damage, follow the procedures
in
and
, respectively, to install and remove the
power module.
Figure 2 Procedure for installing the power module
Figure 3 Procedure for removing the power module
Installing the power module
1.
Wear an ESD wrist strap and make sure the strap makes good
skin contact and is reliably grounded.
2.
Unpack the power module. Make sure the power module meets
the power requirements of the device.
3.
Holding the power module handle with one hand and supporting
the bottom with the other, push the power module into the slot
along the guide rails. Make sure the power module makes good
contact with the connectors on the backplane.
Install the power
module
Connect the power
cord
Turn on the power
switch