H3C SecCenter CSAP-SA, Installation Manual, Page: 34 / 71

1
Replacing hardware options
If you are replacing multiple hardware options, read their replacement procedures and identify
similar steps to streamline the entire replacement procedure.
Replacing the security bezel
Removing the security bezel
1. Insert the key provided with the bezel into the lock on the bezel. Hold down and turn the key 90
degree clockwise to unlock the security bezel, as shown by callout 1 in
Figure 27 .
CAUTION:
To avoid damage to the lock, hold down the key while you are turning the key.
2. Press the latch at the left end of the bezel, open the security bezel, and then release the latch,
as shown by callouts 2 and 3 in
Figure 27 .
3. Pull the right edge of the security bezel out of the groove in the right chassis ear to remove the
security bezel, as shown by callout 4 in
Figure 27 .
Figure 27 Removing the security bezel
Installing the security bezel
1. Press the right edge of the security bezel into the groove in the right chassis ear on the server,
as shown by callout 1 in
Figure 28 .
2. Press the latch at the other end, close the security bezel, and then release the latch to secure
the security bezel into place. See callouts 2 and 3 in
Figure 28 .
3. Insert the key provided with the bezel into the lock on the bezel and lock the security bezel, as
shown by callout 4 in
Figure 28 . Then, pull out the key and keep it safe.