9
destination MAC addresses for these agents and transparently transmits the LLDP frames with
other destination MAC addresses in the VLAN.
•
Service bridge mode
—LLDP supports nearest bridge agents and nearest non-TPMR bridge
agents. LLDP processes the LLDP frames with destination MAC addresses for these agents
and transparently transmits the LLDP frames with other destination MAC addresses in the
VLAN.
To set the LLDP bridge mode:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Set the LLDP bridge mode
to service bridge.
lldp mode service-bridge
By default, LLDP operates in
customer bridge mode.
Setting the LLDP operating mode
Step Command Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Layer 2/Layer 3
Ethernet interface view,
management Ethernet
interface view, Layer
2/Layer 3 aggregate
interface view, or IRF
physical interface view.
interface
interface-type
interface-number
N/A
3.
Set the LLDP operating
mode.
•
In Layer 2/Layer 3 Ethernet
interface view or management
Ethernet interface view:
lldp
[
agent
{
nearest-customer
|
nearest-nontpmr
} ]
admin-status
{
disable
|
rx
|
tx
|
txrx
}
•
In Layer 2/Layer 3 aggregate
interface view:
lldp agent
{
nearest-customer
|
nearest-nontpmr
}
admin-status
{
disable
|
rx
|
tx
|
txrx
}
•
In IRF physical interface view:
lldp admin-status
{
disable
|
rx
|
tx
|
txrx
}
By default:
•
The nearest bridge agent
operates in
txrx
mode.
•
The nearest customer
bridge agent and nearest
non-TPMR bridge agent
operate in
disable
mode.
In Ethernet interface view, if you
do not specify an agent type, the
command sets the operating
mode for nearest bridge agents.
In aggregate interface view, you
can set the operating mode only
for nearest customer bridge
agents and nearest non-TPMR
bridge agents.
In IRF physical interface view,
you can set the operating mode
only for nearest bridge agents.
Setting the LLDP reinitialization delay
When the LLDP operating mode changes on a port, the port initializes the protocol state machines
after an LLDP reinitialization delay. By adjusting the delay, you can avoid frequent initializations
caused by frequent changes to the LLDP operating mode on a port.
To set the LLDP reinitialization delay for ports: