Installation Manual
H3C S7500 Series Ethernet Switches
Chapter 6 Hardware Maintenance
6-9
6.6 Installing the Mounting Brackets and Cable Management
Bracket
Two mounting brackets and a cable management bracket are shipped with the S7500
series.
Take the following steps to install the mounting brackets and the cable management
bracket:
1)
Face the LPU slots of the switch.
2)
Attach the shipped left and right mounting brackets onto the left and right sides of
the chassis, respectively.
3) Install the shipped cable management bracket onto the left side (opposite to the
fan tray) of the chassis, as shown in Figure 6-6.
挂耳
挂耳
走线架
Mounting bracket
Mounting bracket
Cable managem ent bracket
挂耳
挂耳
走线架
Mounting bracket
Mounting bracket
Cable managem ent bracket
Figure 6-6
Install the supplied cable management bracket for the S7506
6.7 Replacing a Memory Module
Note:
This section introduces how to replace a memory module on any type of board.
6.7.1 Upgrade Description
The memory module can be upgraded or replaced according to your requirement.
Generally, you need to upgrade the memory module in one of the following cases:
z
More memory space is needed when you upgrade the application programs of the
switch.
