2
Applicable hardware and software versions
The following matrix shows the hardware and software versions to which this configuration example
is applicable:
Hardware
Software version
S6800 switch series
S6860 switch series
Release 2702
S6861 switch series
Not supported
Restrictions and guidelines
You need to configure PBB only on BEBs.
Procedures
Configuring BEB 1
# Create VLAN 1000 and VLAN 2000.
<BEB1> system-view
[BEB1] vlan 1000
[BEB1-vlan1000] quit
[BEB1] vlan 2000
[BEB1-vlan2000] quit
# Enable L2VPN.
[BEB1] l2vpn enable
# Create a VSI.
[BEB1] vsi test
# Assign PBB I-SID 1 to the VSI.
[BEB1-vsi-test] pbb i-sid 1
# Specify B-VLAN 2000 for the PBB VSI.
[BEB1-vsi-test-1] bvlan 2000
[BEB1-vsi-test-1] quit
[BEB1-vsi-test] quit
# Configure Ten-GigabitEthernet 1/0/1 as a trunk port, assign it to VLAN 2000, and remove it from
VLAN 1. Configure Ten-GigabitEthernet 1/0/1 as an uplink port of the PBB VSI.
[BEB1] interface ten-gigabitethernet 1/0/1
[BEB1-Ten-GigabitEthernet1/0/1] port link-type trunk
[BEB1-Ten-GigabitEthernet1/0/1] port trunk permit vlan 2000
[BEB1-Ten-GigabitEthernet1/0/1] undo port trunk permit vlan 1
[BEB1-Ten-GigabitEthernet1/0/1] pbb uplink vsi test
[BEB1-Ten-GigabitEthernet1/0/1] quit
# Configure Ten-GigabitEthernet 1/0/2 as a trunk port, assign it to VLAN 1000, and remove it from
VLAN 1.
[BEB1] interface ten-gigabitethernet 1/0/2