H3C S6520X-EI Series, Installation Manual

Page: 61 / 68

8-8
Figure 8-4 40G QSFP+ to SFP+ cable
(1) QSFP+ module (2) QSFP+ module side pull latch
(3) SFP+ module side pull latch (4) SFP+ module
IMPORTANT:
•
The fixed QSFP+ ports on the S6520X-30QC-EI, S6520X-54QC-EI, S6520X-30QC-HI, and
S6520X-54QC-HI switches do not support the LSWM1QSTK5 cable.
•
The QSFP-40G-SR4-MM850 and QSFP-40G-CSR4-MM850 transceiver modules support
one-to-four splitting. You can use a QSFP-40G-SR4-MM850 or QSFP-40G-CSR4-MM850
transceiver module to connect a QSFP+ port to four SFP+ ports. The QSFP+ transceiver module
and SFP+ transceiver modules to be connected must be the same in specifications, including
central wavelength and fiber type.
NOTE:
•
As a best practice, use H3C transceiver modules and network cables for the switch.
•
The H3C transceiver modules and network cables are subject to change over time. For the most
recent list of H3C transceiver modules and cables, contact H3C Support or marketing staff.
•
For the specifications of H3C transceiver modules and network cables, see
H3C Transceiver
Modules User Guide
.
QSFP28 port
The S6520X-30HC-EI, S6520X-54HC-EI, S6520X-30HC-HI, and S6520X-54HC-HI switches and
the LSWM2ZQP2P interface card provide QSFP28 ports. You can install QSFP+ modules and
cables in
Table 8-8 , Table 8-9 , and Table 8-10 , and QSFP28 modules and cables in Table 8-11
and Table 8-12 in the QSFP28 ports as needed.
Table 8-11 QSFP28 transceiver modules available for the QSFP28 ports
Model
Central
wavelength
(nm)
Connector
Cable/Fiber
type and
diameter (µm) Modal
bandwidth
(MHz × km) Max
transmission
distance
QSFP-100G-
SR4-MM850
840 to 860 MPO Multi-mode, 50/125
2000 70 m (229.66 ft)
4700 100 m (328.08 ft)
3
4
1
2