70
Verifying the configuration
# Display detailed information about all aggregation groups on the device when the server is not
configured with dynamic link aggregation.
[Device] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Bridge-Aggregation1
Aggregation Mode: Dynamic
Loadsharing Type: NonS
System ID: 0x8000, 000f-e267-6c6a
Local:
Port Status Priority Oper-Key Flag
--------------------------------------------------------------------------------
XGE1/0/1 I 32768 1 {AG}
XGE1/0/2 I 32768 1 {AG}
Remote:
Actor Partner Priority Oper-Key SystemID Flag
--------------------------------------------------------------------------------
XGE1/0/1 0 32768 0 0x8000, 0000-0000-0000 {DEF}
XGE1/0/2 0 32768 0 0x8000, 0000-0000-0000 {DEF}
The output shows that Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2 are in Individual state
when they do not receive LACPDUs from the server. Both Ten-GigabitEthernet 1/0/1 and
Ten-GigabitEthernet 1/0/2 can forward packets and back up each other.
Layer 3 static aggregation configuration example
Network requirements
As shown in
:
•
Configure a Layer 3 static aggregation group on both Device A and Device B.
•
Configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
Figure 16
Network diagram
Configuration procedure
1.
Configure Device A:
# Create Layer 3 aggregate interface Route-Aggregation 1, and configure an IP address and
subnet mask for the aggregate interface.
<DeviceA> system-view