4-43
incremental-interval
: LSA generation incremental interval in milliseconds, in the range 10 to 60000.
The default is 5000 milliseconds.
Description
Use the
lsa-generation-interval
command to configure the OSPF LSA generation interval.
Use the
undo lsa-generation-interval
command to restore the default.
The LSA generation interval defaults to 5 seconds.
With this command configured, when network changes are not frequent, LSAs are generated at the
initial-interval.
If network changes become frequent, LSA generation interval is incremented by a
specified value each time a generation happens, up to the
maximum-interval
.
Related commands:
lsa-arrival-interval
.
Examples
# Configure the maximum LSA generation interval as 2 seconds, minimum interval as 100
milliseconds and incremental interval as 100 milliseconds.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] lsa-generation-interval 2 100 100
lsdb-overflow-limit
Syntax
lsdb-overflow-limit
number
undo lsdb-overflow-limit
View
OSPF view
Default Level
2: System level
Parameters
number
: Specifies the upper limit of external LSAs in the LSDB, in the range 1 to 1000000.
Description
Use the
lsdb-overflow-limit
command to specify the upper limit of external LSAs in the LSDB.
Use the
undo
lsdb-overflow-limit
command to restore the default.
External LSAs in the LSDB are not limited by default.
Examples
# Specify the upper limit of external LSAs as 400000.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] lsdb-overflow-limit 400000
maximum load-balancing (OSPF view)
Syntax
maximum load-balancing
maximum
