H3C S5560-HI Series, Installation Manual, Page: 70 / 85

62
SFP port
The S5560-56F-HI switch provides 48 fixed SFP ports on the front panel. You can install the 1000 Mbps
SFP transceiver modules in Table 19 and 100 Mbps SFP transceiver modules in Table 22 in the SFP ports.
Table 22 100 Mbps SFP transceiver modules available for the SFP ports
Module description
Central
wavelengt
h (nm)
Connector
Cable/fiber diameter
( μ m)
Max transmission
distance
SFP-FE-SX-MM1310-A 1310 LC
Multi-mode, 50/125
2 km (1.24 miles)
Multi-mode, 62.5/125
SFP-FE-LX-SM1310-A 1310 LC Single-mode, 9/125 15 km (9.32 miles)
SFP-FE-LH40-SM1310 1310 LC Single-mode, 9/125 40 km (24.85 miles)
SFP-FE-LX-SM1310-BIDI
TX: 1310
RX: 1550
LC Single-mode, 9/125 15 km (9.32 miles)
SFP-FE-LX-SM1550-BIDI
TX: 1550
RX: 1310
NOTE:
•
Use the SFP-FE-LX-SM1310-BIDI and SFP-FE-LX-SM1550-BIDI modules in pairs.
•
As a best practice, use only H3C SFP transceiver modules.
• The SFP transceiver modules available for the switch are subject to change over time. For the most
up-to-date list of SFP transceiver modules, consult your H3C sales representative or technical support
engineer.
•
For the specifications for the H3C SFP transceiver modules, see
H3C Transceiver Modules User Guide.
QSFP+ port
The LSWM2QP2P interface card provides QSFP+ ports. You can install the QSFP+ transceiver modules
in Table 23 and the QSFP+ cables in Table 24 in the QSFP+ ports.
Table 23 QSFP+ transceiver modules available for the QSFP+ ports
QSFP+ transceiver
module
Central
wavelength
(nm)
Connector
Fiber type
and
diameter
( μ m)
Modal
bandwidth
(MHz × km)
Max transmission
distance
QSFP-40G-SR4-MM
850
850 MPO
Multi-mode,
50/125
2000 100 m (328.08 ft)
4700 150 m (492.12 ft)
QSFP-40G-CSR4-M
M850
850 MPO
Multi-mode,
50/125
2000 300 m (984.25 ft)
4700 400 m (1312.33 ft)
QSFP-40G-LR4-WD
M1300
Four lanes:
•
1271.
LC
Single-mode
, 9/125
N/A 10 km (6.21 miles)