H3C S5500-EI series, Configuration Manual

Page: 109 / 457

92
Follow these steps to make them compatible:
To do… Use the command… Remarks
Enter system view system-view
—
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
Required
Enable compatibility with
RFC 1583
rfc1583 compatible
Optional
Enabled by default
NOTE:
To avoid routing loops, H3C recommends configuring all the routers to be either compatible or
incompatible with RFC 1583.
Logging neighbor state changes
Follow these steps to enable the logging of neighbor state changes:
To do… Use the command… Remarks
Enter system view system-view
—
Enter OSPF view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
—
Enable the logging of neighbor
state changes
log-peer-change
Optional
Enabled by default
Configuring OSPF network management
With trap generation enabled, OSPF generates traps to report important events. Traps fall into the
following levels.
•
Level-3—fault traps
•
Level-4—alarm traps
• Level-5—normal but important traps
•
Level-6—notification traps
The generated traps are sent to the information center of the device. The output rules of the traps such as
whether to output the traps and the output direction are determined according to the information center
configuration. (For information center configuration, see Network Management and Monitoring
Configuration Guide .)
Follow these steps to configure OSPF network management:
To do… Use the command… Remarks
Enter system view system-view
—
Bind OSPF MIB to an
OSPF process
ospf mib-binding process-id
Optional
The OSPF process with the smallest
process-id is bound with OSPF MIB
by default.