77
LED mark
Status
Description
Off
The RPS DC input is abnormal or no RPS is connected.
Port mode LED
To show more information about the switch through the port status LEDs, all S5130-HI switches
except the S5130-54QS-HI switch provides a port mode LED. The port mode LED indicates the type
of information that the network port LEDs are showing.
Table 26 Port mode LED description
LED mark
Status
Description
Mode
Steady green
The port status LEDs are showing port rates.
Flashing green (1 Hz) (available only for
S5130-30C-PWR-HI and
S5130-54C-PWR-HI switches)
The port status LEDs are showing the status
of PoE power supply on the ports.
Flashing yellow
The port status LEDs indicates the IRF
member ID of the switch. For example, if the
ports 1 to 5 are steady green, the IRF
member ID of the switch is 5.
10/100/1000BASE-T autosensing Ethernet port LED
The switch provides a status LED for each 10/100/1000BASE-T autosensing Ethernet port. The port
status LED and the port mode LED indicate the operating state of the 10/100/1000BASE-T
autosensing Ethernet port in conjunction.
Table 27 10/100/1000BASE-T autosensing Ethernet port LED description
Port mode LED (Mode)
status
Port LED status
Description
Steady green (rate mode)
Steady green
The port is operating at 1000 Mbps. The port
LED fast flashes when the port is sending or
receiving data.
Steady yellow
The port is operating at 10/100 Mbps. The
port LED fast flashes when the port is
sending or receiving data.
Flashing yellow (3 Hz)
POST has failed on the port.
Off
No link is present on the port.
Flashing green (1 Hz) (PoE mode,
available only for
S5130-30C-PWR-HI and
S5130-54C-PWR-HI switches)
Steady green
PoE power supply is normal.
Flashing green (3 Hz)
The device attached to the port requires
power higher than the maximum or currently
available PoE output power on the port.
Steady yellow
The port is experiencing a PoE failure.
Flashing yellow (3 Hz)
POST has failed on the port.
Off
The port is not supplying PoE power.
Flashing yellow (IRF mode)
Steady green
The port status LED indicates the IRF
member ID of the switch. For example, if the
ports 1 to 5 are steady green, the IRF
