11
Installing a power module
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Unpack the power module and verify that the power module model is as required.
3.
Remove the filler panel (if any) from the target slot.
If you require only one power module, install it in power module slot 1 and make sure a filler
panel is installed in power module slot 2.
4.
Orient the power module with the upside up. Grasp the handle of the power module with one
hand and support its bottom with the other, and slide the power module slowly along the guide
rails into the slot. See callout 1 in
To prevent damage to the power module and the connector on the switch backplane, insert the
power module gently. If you encounter a hard resistance or the power module tilts while
inserting the power module, pull out the power module, realign it with the slot, and then insert it
again.
5.
Fasten the captive screws on the power module with a Phillips screwdriver to secure the power
module in the chassis. See callout 2 in
.
If the captive screw cannot be tightly fastened, examine the installation of the power module.
Figure 16 Installing a PSR150-A power module
Removing a power module
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Power off the power module and remove the power cord.
3.
Loosen the captive screws on the power module with a Phillips screwdriver until they are
completely disengaged from the chassis.
4.
Grasp the handle of the power module with one hand and pull the module part way out. Support
the module bottom with the other hand, and pull the power module slowly along the guide rails
out of the slot.
5.
Place the removed power module in an antistatic bag.